A limestone row house roof is usually a flat roof hidden behind a stone or metal cornice, draining toward a scupper at the back of the house. Good care protects more than the top floor. It keeps water away from the soft, porous limestone below, which can stain, crumble, and flake when roof water finds its way into the stone.
Many of these Brooklyn homes went up more than a century ago. Their roofs have seen decades of patches, new layers, and changing weather. Here is how to keep one in good shape and protect the facade that makes these homes special.
The Roof Behind the Cornice
From the sidewalk, you see the pale stone front and a decorative cornice along the top. Behind that cornice sits a flat roof, usually covered in modified bitumen or rubber over older layers of tar. A short parapet wall rises along the front, and another often runs along the back.
Most of these roofs also have a roof hatch, a skylight over the stairs, and at least one brick chimney. Rainwater is meant to run rearward and exit through an opening in the back wall. Each of those features needs sound flashing to keep water where it belongs.
Why the Roof Matters for Limestone
Limestone is softer and more absorbent than brick. When water from the roof runs over the cornice or soaks into the top of the front wall, the stone drinks it in. Freeze and thaw cycles then expand that water inside the stone, which can cause flaking, cracking, and loose pieces.
Water also carries dirt and minerals that leave dark streaks on the facade. Once a limestone front starts to stain or crumble, repairs become slow, careful masonry work. A watertight roof edge is the simplest way to prevent that.
Common Limestone Row House Roof Problems
Century-old limestone homes tend to share the same weak spots up top. These are the ones we see most:
Front coping joints: open joints in the stone cap on the front parapet
Cornice trouble: rusted metal, rotted wood framing, or clogged hidden gutters
Front edge flashing: open seams along the stone wall at the street side
Rear drainage: clogged scuppers and leaders that back water up
Sagging spots: old joists that let water pool near the front
Chimney flashing: worn seals around old brick stacks
Most of these start small. Catching them early keeps water out of both the roof and the stone.
The Front Edge: Parapet, Coping, and Cornice
The front edge carries the most risk on a limestone row house. The parapet holds the cornice in place, and the coping stones on top protect the wall from rain. When the joints between those stones open up, water drips straight down into the facade.
Many limestone homes have sheet metal cornices that hide a narrow gutter behind them. When that gutter rusts through or clogs, water spills into the wall instead of draining away. Repainting the cornice, keeping the gutter clear, and resealing the coping joints protect both the roof edge and the stone below.
Keep Tar Off the Stone
One of the most common mistakes on limestone homes is a quick patch with roofing cement smeared onto the stone. Black tar stains limestone, traps moisture against it, and makes later repairs much harder. It may stop a leak for a season, but it damages the facade over time.
Proper flashing tucks metal into the mortar joints, not across the face of the stone. Repairs to the stone itself call for a mason who uses compatible mortar. Ask any roofer working on your home how they plan to seal the front edge before they start.
Drainage From Front to Back
Ideally, rain lands on the roof and heads straight for the rear outlet. A century of settling changes that. Old wood joists can dip, and stacked layers of past roofing can leave hollows. Water then pools near the front, right above the stone.
Regular drain cleaning helps, but it cannot fix a roof that slopes the wrong way. When ponding keeps returning near the front, a roofer may recommend tapered insulation or framing repairs during the next replacement to steer water back where it belongs.
A Yearly Routine for Limestone Homes
A simple routine keeps both the roof and the stone in good shape. Build these checks into your calendar:
Spring: look for open coping joints and new stains on the facade
Early summer: check cornice paint and the hidden gutter behind it
Fall: clear leaves from the rear scupper and leader
After storms: scan the front edge and chimney for loose flashing
Every few years: have a mason look at the stone and mortar
Small fixes caught this way rarely grow into major facade repairs. They also give you a written history that helps any roofer or mason who works on the house later.
Replacing the Roof on a Century-Old Home
A full replacement is the best chance to fix long-standing problems. With the old layers removed, crews can check the joists for rot, repair or sister weak framing, and add insulation that makes the top floor more comfortable. They can also rebuild the flashing at the front and rear parapets properly.
Several Brooklyn limestone blocks fall inside landmark districts. There, the city may review any work that changes the street view. Roof work hidden behind the cornice usually draws less attention than changes to the cornice or parapet itself. Ask your roofer whether anything in the scope will affect what shows from the sidewalk.
Protecting Your Limestone Row House Roof
A limestone row house roof protects one of Brooklyn’s most beautiful building styles, and the stone depends on it. Keep the front edge sealed, the cornice gutter clear, the rear drain open, and tar off the stone. For more on caring for every part of a row house roof, see our Brooklyn row house roof guide.
Limestone homes in Bay Ridge, Prospect Lefferts Gardens, and other Brooklyn neighborhoods are familiar ground for N.V. Roofing Services, a family business with decades of combined experience. Read about our residential roofing services, or ring (646) 717-3737 to book a visit.
FAQ Section
Q: Why does my limestone facade stain below the roof?
A: Water from the roof edge, cornice, or open coping joints soaks into the stone and leaves dark streaks.
Q: Can roofing cement be used on limestone?
A: It should not be. Tar stains limestone and traps moisture, so proper metal flashing and compatible mortar work better.
Q: What type of roof does a limestone row house have?
A: Most have a flat roof behind the front cornice, draining toward a scupper and leader at the back.
Q: Do limestone row houses need landmark approval for roof work?
A: Homes in historic districts may need approval for visible changes, while hidden roof work usually draws less review.
About the Author
Billy Duka is a second-generation roofer at N.V. Roofing Services, a family-owned Brooklyn company with decades of combined roofing experience. He writes guides that help owners protect Brooklyn’s historic row houses from the roof down.